|
The Nauta Cone screw mixer is generally used in case of applications that require gentle mixing action and minimal heat generation without any product distortion.
- The Nauta Mixer is Ideal mixer to mix various small lots to make uniform one lot or to mix many large proportions of powders to a uniform product in Food, Chemical Pharmaceutical, Minerals, Guar Gum, Starch and Cellulose. The Nauta mixer offers low operative cost than any other types of mixers.
- The Nauta mixer is a planetary rotating screw near the wall of cone without end resting of screw.
- The principle of blending is based on the differential travel speeds of product particles in the conical section of the vessel.
- The material from the bottom section of vessel is lifted by the screw and spread over the upper sections.
- The screw agitator turning on its axis produces a lifting action as it spirals the material in an upward flow.
- At the same time the screw orbits the tank, the screw removes material away from wall and deflects it into the centre of the tank setting up a spiral current thought the batch.
- The material lifted by the screw gravitates downwards thoroughly intermixing with material being spiraled upward. This results in most intimate intermingling of all ingredients.
- The nauta mixer is mixes the powders but also breaks the lumps. This blender/mixer can also be used for applications that requires high shear mixing, which can be accomplished using separately driven lump breakers.
- The sizes of Nauta mixer available are 500 liter to 5000 liter.
- Nauta Mixer achieves excellent accuracy in mixing even when the components are present in minor quantity.
- Higher efficiency achieved compared to horizontal blenders.
- Easy addition of liquid.
- Shorter mixing time.
- Low power consumption.
- Gentle Mixing achieved.
- Rotary discharge valves and pneumatic discharge systems employed for faster discharge rate.
- Easy to clean: These conical mixers are easily cleanable either in a dry way using special extra large doors on the vessel or in a wet way using spraying devices.
- Designed as per cGMP – Current Good Manufacturing Practices & Non GMP STANDARD Model.
- Contact parts in AISI 316, AISI 304 or MS as desired by customer.
|
